CarObdCode.Com

0

P0562 Chrysler Charging System Low Voltage

Author: carobdcode/Categories: Chrysler/Time: 2013-08-12 07:13
43

P0562 Chrysler Charging System Low Voltage

Possible causes
- Low battery charge
- Battery defective
- Loose or missing alternator drive belt
- Faulty alternator
- Open or short system voltage circuit
Tech description
Start by recharging or replacing the battery.
What about the obd code?
The Engine Control Module (ECM) has detected that the electrical system voltage level is out of range.
Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Slow engine start
- Low battery power
P0562 Chrysler Description

The battery supplies electricity to the Engine Control Module (ECM) even when the ignition switch is OFF. This electricity allows the ECM to store data such as Detected Trouble Code (DTC) history, freeze frame data, fuel trim values and other data. If the battery voltage falls below a minimum level, the ECM will conclude that there is a fault in the power supply circuit. The next time the engine starts, the ECM will turn on the Malfunction Indicator Light (MIL) and a DTC will be set.

Chrysler Vehicle:Chrysler 200,Chrysler 300,Chrysler 300M,Chrysler Crossfire,Chrysler PT Cruiser,Chrysler Town & Country,Chrysler Voyager

Note:

1. Need to look up additional OBD-II Trouble Codes(DTC), use the search box. Enter the 5 character trouble codes in the search box and submit the search. You can repeat the search as many times as you need, one diagnostic code per search.
2. Don't assume a particular OBDii code means the same for other automotive manufacturers as there are many manufacturer specific codes in use.
3. If your trouble codes are for a different automotive, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other manufactures. The search only looks at OBD codes valid for the currently selected manufacturer.
4. This code is for reference only.
5. Help us improve CarObdCode.com. Tell us fix the code. Any information is appreciated. Thanks.

Leave a Reply