P2138 Volvo Throttle Pedal Position Sensor/Switch D/E Voltage Correlation

P2138 Volvo Throttle Pedal Position Sensor/Switch D/E Voltage Correlation

Possible causes
– Faulty Accelerator Pedal Position (APP) Sensor
– Accelerator Pedal Position (APP) Sensor harness is open or shorted
– Accelerator Pedal Position (APP) Sensor circuit poor electrical connection
– Faulty Engine Control Module (ECM)
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
P2138 Volvo Description

The Accelerator Pedal Position (APP) sensor is mounted on the accelerator pedal to detect the angle of the accelerator pedal. This sensor is electronically controlled and uses Hall-effect elements.

In the accelerator pedal position sensor, the voltage applied to terminals VPA and VPA2 of the Engine Control Module (ECM) changes between 0 V and 5 V in proportion to the angle of the accelerator pedal. The VPA is a signal to indicate the actual accelerator pedal angle and is used for the engine control. VPA2 is used to detect malfunctions of the sensor itself.

The ECM monitors the accelerator pedal angle from VPA and VPA2 signal outputs, and controls the throttle motor based on these signals.

Volvo Vehicle:Volvo C70,Volvo S40,Volvo XC90,Volvo XC70,Volvo XC60,Volvo V70,Volvo V50,Volvo V40,Volvo S90,Volvo S80,Volvo S60

Leave a Reply

Your email address will not be published. Required fields are marked *