| P0336 | Crankshaft position (CKP) sensor circuit range/performance problem |
|---|---|
|
DETECTION CONDITION
|
• The PCM monitors the input voltage from the CKP sensor signal. If the voltages at PCM deviates from the threshold, the PCM determines that the there is a CKP sensor problem.
|
|
POSSIBLE CAUSE
|
• CKP sensor malfunction
• CKP sensor is dirty.
• CKP sensor pulse wheel malfunction
• PCM malfunction
|
Diagnostic procedure
| STEP | INSPECTION | ACTION | |
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has the FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record FREEZE FRAME DATA on repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
• Verify related service bulletins and/or on-line repair information availability.
• Is any related repair information available?
|
Yes
|
Perform repair or diagnosis according to available repair information.
• If vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY CURRENT SIGNAL STATUS: IS CONCERN INTERMITTENT OR CONSTANT?
• Connect the M-MDS to the DLC-2.
• Clear the DTC from the PCM memory using the M-MDS.
• Run the vehicle under the FREEZE FRAME DATA stored condition.
• Is the same DTC present?
|
Yes
|
Go to the next step.
|
|
No
|
Intermittent concern exists.
Perform the “INTERMITTENT CONCERNS TROUBLESHOOTING”.
|
||
|
4
|
INSPECT CKP SENSOR
• Turn the engine switch off.
• Inspect the CKP sensor.
• Is the CKP sensor normal?
|
Yes
|
Go to the next step.
|
|
No
|
Inspect the CKP sensor pulse wheel for damage.
Replace the CKP sensor or CKP sensor pulse wheel, then go to the next step.
|
||
|
5
|
VERIFY THAT DTC P0336 TROUBLESHOOTING IS COMPLETED
• Make sure to reconnect all disconnected connectors.
• Turn the engine switch to the ON position. (Engine off).
• Clear the DTC from the PCM memory using the M-MDS.
• Run the vehicle under the FREEZE FRAME DATA stored condition.
• Is the same DTC present?
|
Yes
|
Replace the PCM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
6
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the after repair procedure.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||