P0340 Audi Camshaft Position Sensor Circuit Bank 1 Sensor 1

P0340 Audi Camshaft Position Sensor Circuit Bank 1 Sensor 1

Possible causes
– Faulty Camshaft Position Sensor
– Camshaft Position Sensor harness is open or shorted
– Camshaft Position Sensor circuit poor electrical connection
– Faulty starter motor
– Starting system circuit
– Dead (Weak) battery
Tech description
What about the obd code?
The camshaft position sensor signal is not detected by the Engine Control Module(ECM) during the first few seconds of engine cranking
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
– Lack/Loss of Power
– Engine Stall
P0340 Audi Description

The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning. This information is used by the Engine Control Module(ECM) to control ignition and fuel injection. The camshaft position sensor senses the retraction of camshaft (intake) to identify a particular cylinder. The camshaft position sensor senses the piston position. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.

When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.

When the crankshaft position sensor (POS) system becomes inoperative, the camshaft position sensor provides various controls of engine parts instead, utilizing timing of cylinder identification signals.

Audi Vehicle:Audi A1,Audi A3,Audi A1,Audi A3,Audi A1,Audi A3,Audi A4,Audi A5,Audi Q3,Audi A5,Audi Q5,Audi A3,Audi A4,Audi A5,Audi TT,Audi Q3,Audi Q5,Audi S3,Audi TTS,Audi RS 3,Audi TT RS,Audi A7,Audi Q7,Audi A8,Audi A6,Audi S4,Audi S5,Audi Q5,Audi S6,Audi S8,Audi S5,Audi A8,Audi R8 V8,Audi RS 5,Audi S6,Audi R8 V10,Audi R8 GT,Audi A8L