P0449 Audi EVAP System Vent Valve/Solenoid Circuit

P0449 Audi EVAP System Vent Valve/Solenoid Circuit

Possible causes
– Purge Control Valve harness is open or shorted
– Purge Control Valve electrical circuit poor connection
– Faulty canister vent control valve
What about the obd code?
The Engine Control Module (ECM) has determined that a malfunction exists in the electrical circuit for the vent valve/solenoid in the evaporative emission control system.
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
P0449 Audi Description

The Evaporative Emission System (EVAP) canister vent control valve is located on the EVAP canister and is used to seal the canister vent. This solenoid (the EVAP canister vent control valve) responds to signals from the Engine Control Module (ECM). When the ECM sends an ON signal, the coil in the solenoid valve is energized.

A plunger will then move to seal the canister vent. The ability to seal the vent is necessary for the on board diagnosis of other evaporative emission control system components.

This solenoid valve is used only for diagnosis, and usually remains opened. When the vent is closed, under normal purge conditions, the evaporative emission control system is depressurized and allows EVAP Control System (Small Leak) diagnosis.

Audi Vehicle:Audi A1,Audi A3,Audi A1,Audi A3,Audi A1,Audi A3,Audi A4,Audi A5,Audi Q3,Audi A5,Audi Q5,Audi A3,Audi A4,Audi A5,Audi TT,Audi Q3,Audi Q5,Audi S3,Audi TTS,Audi RS 3,Audi TT RS,Audi A7,Audi Q7,Audi A8,Audi A6,Audi S4,Audi S5,Audi Q5,Audi S6,Audi S8,Audi S5,Audi A8,Audi R8 V8,Audi RS 5,Audi S6,Audi R8 V10,Audi R8 GT,Audi A8L