P0516 JEEP Battery Temperature Sensor Circuit Low

Possible causes

– Faulty Battery Temperature Sensor
– Battery Temperature Sensor harness is open or shorted
– Battery Temperature Sensor circuit poor electrical connection

What about the obd code?

Battery temperature sensor output value is 0.2 V or less for 0.5 seconds or more with the ignition switch ON

Symptoms

– Engine Light ON (or Service Engine Soon Warning Light)
– Engine overheating

P0516 JEEP Description

The Battery Temperature Sensor (BTS) is attached to the battery tray located under the battery.

The BTS is used to determine the battery temperature and control battery charging rate. This temperature data, along with data from monitored line voltage, is used by the PCM to vary the battery charging rate. System voltage will be higher at colder temperatures and is gradually reduced at warmer temperatures.

The PCM sends 5 volts to the sensor and is grounded through the sensor return line. As temperature increases, resistance in the sensor decreases and the detection voltage at the PCM increases.

The BTS is also used for OBD II diagnostics. Certain faults and OBD II monitors are either enabled or disabled, depending upon BTS input (for example, disable purge and enable Leak Detection Pump (LDP) and O2 sensor heater tests). Most OBD II monitors are disabled below 20