P0654 Isuzu Engine Speed Output Circuit

P0654 Isuzu Engine Speed Output Circuit

Possible causes

– Faulty Instrument Cluster
– Instrument Cluster harness is open or shorted
– Instrument Cluster circuit poor electrical connection
– Faulty PCM

What about the obd code?

If the fault detection circuit senses a voltage other than what is expected, the fault line status changes causing the P0654 Isuzu code will set.

Symptoms

– Engine Light ON (or Service Engine Soon Warning Light)

P0654 Isuzu Description

The Instrument Panel Cluster (IPC) supplies a voltage to the Engine Speed Output circuit. The Powertrain Control Module (PCM) creates the Engine Speed Output signal by rapidly grounding this circuit via an internal switch called a driver. The other components on this circuit recognize the voltage being pulled to ground as an indication of engine speed. The driver supplies the ground for the component being controlled. Each driver has a fault line which the PCM monitors. When the PCM commands a component ON, the voltage of the control circuit should be low (near 0 volts). When the PCM commands the control circuit to a component OFF, the voltage potential of the circuit should be high (near battery voltage).

Isuzu Vehicle:2013 Isuzu,2012 Isuzu,2011 Isuzu,2010 Isuzu,2009 Isuzu,2008 Isuzu,2007 Isuzu,2006 Isuzu,2005 Isuzu,2004 Isuzu,2003 Isuzu,2002 Isuzu,2001 Isuzu,2000 Isuzu,1999 Isuzu,1998 Isuzu,1997 Isuzu,1996 Isuzu,Isuzu Rodeo,Isuzu Trooper,Isuzu Ascender