P0800 Buick Transfer Case Control System (Malfunction Indicator Light (MIL) Request)

P0801 Buick Reverse Inhibit Solenoid Control Circuit

Possible causes
– Faulty Reverse Inhibit Solenoid
– Reverse Inhibit Solenoid harness is open or shorted
– Reverse Inhibit Solenoid circuit poor electrical connection
What about the obd code?
When the Reverse Inhibit solenoid energizes, the operator can shift the transmission into reverse. The Powertrain Control Module (PCM) enables the Reverse Inhibit solenoid whenever vehicle speed is below 5 mph. When the vehicle speed is above 5 mph, the PCM de-energizes the solenoid, which prevents the operator from shifting the transmission into reverse.
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
P0801 Buick Description

An ignition voltage is supplied to the Reverse Inhibit solenoid. The Powertrain Control Module (PCM) controls the solenoid by grounding the control circuit via an internal switch called a driver. The driver supplies the ground for the component being controlled. Each driver has a fault line which the PCM monitors. When the PCM commands a component ON, the voltage of the control circuit should be low (near 0 volts). When the PCM commands the control circuit to a component OFF, the voltage potential of the circuit should be high (near battery voltage). If the fault detection circuit senses a voltage other than what is expected, the fault line status changes causing the P0801 Buick code to set.

Buick Vehicle:Buick Regal – ?Buick Riviera – ?Buick LaCrosse – ?David Dunbar Buick – Buick Century – Buick LaCrosse – Buick LeSabre – Buick Lucerne – Buick Park Avenue – Buick Regal – Buick Verano – Buick Enclave – Buick Encore – Buick Rainier – Buick Rendezvous – Buick Terraza – Buick Riviera