P1000 BMW On Board Diagnostic System Readiness Test Not Complete

P1000 BMW On Board Diagnostic System Readiness Test Not Complete

Possible causes
– The vehicle is new from the factory.
– Battery or Powertrain Control Module (PCM) had recently been disconnected.
– An OBD monitor failure occurred before completion of an OBD drive cycle.
– PCM Detected Trouble Codes (DTC) have recently been cleared with a scan tool.
Tech description
This code just means that the PCM didn’t complete a full diagnose cycle, and is set when the battery have been disconnected, codes have been cleared or sometimes even when the vehicle have been towed. No scanner it’s necessary to clear the code, driving the vehicle for a few minutes (sometimes more) to complete the diagnose cycle will clear the code. Clearing the code will reset the light unless other codes present.
What about the obd code?
If DTC P1000 BMW is triggered after DTCs have been cleared, all engine management OBD diagnostic monitor drive cycles have not been cleared.
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
P1000 BMW Description

The On Board Diagnostic (OBD) monitors are performed during the OBD Drive Cycle. P1000 BMW is stored in continuous memory if any of the OBD monitors do not carry out their full diagnostic check.

BMW Vehicle:BMW F650GS,BMW F800S,BMW F800ST,BMW G450X,BMW G650 Xmoto,BMW R1200GS,BMW R1200R,BMW R1200RT,BMW R1200S,BMW K1200LT,BMW K1300GT,BMW K1300R,BMW K1300S,BMW K1600GT and K1600GTL,BMW S1000RR,BMW E36/5,BMW E36/7,BMW E36/8,BMW E38,BMW E38/2,BMW E38/3,BMW E39,BMW E46/5,BMW E46/4,BMW E46/3,BMW E46/2,BMW E46/C,BMW E52,BMW E53,BMW E60,BMW E61,BMW E62,BMW E63,BMW E64,BMW E65,BMW E66,BMW E67,BMW E68,BMW E70,BMW E71,BMW E72,BMW E81,BMW E82,BMW E83,BMW E84,BMW E85,BMW E86,BMW E87,BMW E88,BMW E89,BMW E90,BMW E91,BMW E92,BMW E93,BMW F01,BMW F02,BMW F03,BMW F04,BMW F06,BMW F07,BMW F10,BMW F11,BMW F12,BMW F13,BMW F15,BMW F18,BMW F20,BMW F21,BMW F22,BMW F25,BMW F26,BMW F30,BMW F31,BMW F32,BMW F33,BMW F34,BMW F35,BMW F36,BMW F80,BMW F82