P2770 Volkswagen Torque Converter Clutch Solenoid Circuit High

P2770 Volkswagen Torque Converter Clutch Solenoid Circuit High

Possible causes
- Open in shift solenoid valve DSL circuit
- Faulty Shift solenoid valve DSL
- Engine Control Module (ECM)
– Engine Light ON (or Service Engine Soon Warning Light)
P2770 Volkswagen Description

The shift solenoid valve DSL is turned “ON” and “OFF” by signals from the Engine Control Module (ECM) in order to control the hydraulic pressure operation, the lock-up relay valve, which then the controls operation of the lock-up clutch.

Torque converter lock-up is controlled by the ECM based on engine rpm, engine load, engine temperature, vehicle speed, transmission temperature, and shift range selection. The ECM determines the lock-up status of the torque converter by comparing the engine rpm (NE) to the input turbine rpm (NT). The ECM calculates the actual transmission gear by comparing input turbine rpm (NT) to counter gear rpm (NC). When conditions are appropriate, the ECM requests “lock-up” by applying control voltage to shift solenoid DSL. When the DSL is opened, solenoid DSL applies pressure to the lock-up relay valve and locks the torque converter clutch. If the ECM detects an open or short in the DSL solenoid circuit, the ECM interprets this as a fault in the DSL solenoid or circuit. The ECM will turn on the MIL and store the DTC.

Volkswagen Vehicle:Volkswagen CC,Volkswagen Eos,Volkswagen Golf,Volkswagen GTI,Volkswagen Jetta,Volkswagen New Beetle,Volkswagen Passat,Volkswagen Routan,Volkswagen Tiguan,Volkswagen Touareg,Volkswagen Beetle,Volkswagen Golf,Volkswagen Polo,Volkswagen Touran,Volkswagen up,Volkswagen Sharan,Volkswagen Santana,Volkswagen Lavida

Leave a Reply

Your email address will not be published. Required fields are marked *